>>  Home  >>  News  >>  Products  >>  SpareParts Listing  >>  Dealers  >>  FAQ  >>  Race Report  >>  Contact  >>  Wallpaper RB PRODUCTS USA 5611 Colleyville Blvd #160 Colleyville, Texas. 76034 Tel: 817-876-9707 Fax: 817-581-1560   FAQ 09/09/2010 05:03   Frequently asked questions Faq Main Browse a category GeneralEnginesCarburetor settingsPipes & ManifoldsGlowplugsAirfilters   Airfilter Maintenance and Attention. A properly maintained air filter is essential to the life and performance of every nitro engine. NEV... Choosing the right Glowplug Choosing the right Glowplug for your engine is not so difficult as you think it is, just keep ... Doooo's and Don'ts Do\'s Keep your engine clean, both internally and externally. Inspect your engine on a r... Effects of pipe and manifold length on performance. To get the best performances out of your RB Concept engine we suggest you use our original RB Concep... How do I set the carburetor To be able to adjust the carburetor of a nitro engine correctly, you need patience and must try and ... How much RPM and HP? We have many request of how much rpm or HP our engines make and all we can tell you is that si... How to get Help or Assistance? If you have a problem with your RB Concept engine, we first want to suggest that you return with you... How to loosen or remove the pinch-bolt style fixation of the carburetor. Here is the way we remove a carburetor(the two halves of the pinch bolt tend to stick inside the cra... How to maintain your engine in top shape There are some important things you should know about nitro-engines... These high performance engine... How to re-assemble a pullstart unit. IMPORTANT: It is vitally important to protect your eyes with adequate safety glasses before yo... How to remove the Main-Bearing when stuck on Crankshaft. Due to the tight tollerances used, it can somtimes happen that the main-bearing gets stuck on the cr... How to start the engine? Note: The piston of the engine can feel tight at the top of its stroke (TDC) when the engine is cold... Initial .12(2.11cc) rotary carburetor settings ROTARY carburetor settings.  The RB Concept carburetors of the 2.11cc(.12) engines are... Initial .12(2.11cc) slide carburetor settings The RB Concept carburetors of the 2.11cc(.12) engines are set at the factory with a special va... Initial .15(2.5cc) slide carburetor settings of a Big-Block .15 RB Concept engine. The RB Concept carburetors of the 2.5cc(.15) engines are set at the factory with a special vac... Initial .21(3.5cc) carburetor settings of an RB Concept engine. The RB Concept carburetors of the 3.5cc(.21) engines are set at the factory with a special vac... Running-in Procedure A nitro engine is a mechanical masterpiece and requires careful running in to allow the internal par... The engine runs on when the throttle is closed, this causes a problem braking. For the engine to do this when the throttle is in the closed position, then there is still... What RotoStart system is compatible with RB Engines, The HPI rotostart system you can use for our engines you can find on the following link : http:... What to do with a pré-run factory engine A pré-run factory engine can be ordered in combination with a new engine only, it is not possible t... Why does the piston blocks at TDC(Top Dead Center)? The piston of these nitro engines block at TDC(Top Dead Center) especially when the engines are bran...      ©Copyright 2007- 2010.